A range of durable augers are based on a threaded joint system. Items in this section may be interchanged and extended to any depth required. For increased versatility and convenience it may be preferred to have sectional augers. When joined with a bayonet and sleeve connection, the resulting unit has a working length of 1.25 metres. If required the augers may be further extended by either 0.5 or 1 metre increments.
One piece model, length 1.25 metres. This is suitable for most soft soil types.
Suitable for use in most soft soil types.
3 cutting head sizes available
info »
One piece model, length 1.25 metres. This is suitable for most soft soil types.
Suitable for use in most soft soil types.
3 cutting head sizes available.
info »
One piece model, length 1.25 metres. This is suitable for most soft soil types.
Suitable for use in most soft soil types.
3 cutting head sizes available.
info »
One piece model, length 1.25 metres. This auger is used in hard stiff soils above and below ground water level. It is also satisfactory in most fine gravel soils.
2 cutting head sizes available
info »
One piece model, length 1.25 metres. This auger is used in hard stiff soils above and below ground water level. It is also satisfactory in most fine gravel soils.
2 cutting head sizes available
info »
70 mm diameter cutting head.
600 mm long with bayonet connection.
For use with 510-109, 510-110 and 510-111.
info »
One piece model, length 1.25 metres with 70 mm diameter cutting head. Used when the Riverside auger is inadequate to deal with the larger sizes of gravel and stones.
info »
For collecting samples from the top 50 mm of the turf. Diameter 23 mm, operating length 50 mm, total length 600 mm.
info »
One piece model with 30 mm diameter cutting head. Operating length 1 metre.
info »
40 mm diameter cutting head. 600 mm long with bayonet connector. For use with 510-109, 510-110 and 510-111.
info »
One piece head and rod, approximately 600 mm long with bayonet connection for use with 510-109.
Head Size/Dia: 40 mm
info »
One piece head and rod, approximately 600 mm long with bayonet connection for use with 510-109.
Head Size/Dia: 70 mm
info »
One piece head and rod, approximately 600 mm long with bayonet connection for use with 510-109.
Head Size/Dia: 100 mm
info »
For augering all types of soil above and below the water table to a depth of 5 or 7 metres. Supplied complete in an aluminium transport case with padlock.
info »
For augering all types of soil above and below the water table to a depth of 5 or 7 metres. Supplied complete in an aluminium transport case with padlock.
info »
For sampling to a depth of 10 metres. Supplied complete in an aluminium transport case.
info »
This kit contains the necessary items to sample above and below the water table and comprises the handle and beating head, Edelman auger, a Riverside auger, a closed ring auger and spare cutting shoe, a hammering head and guide cylinder for the rings, a nylon headed hammer, 3 extension rods 500 mm long, 24 numbered sample rings with end caps in an aluminium case, a bent spatula, brush and a carrying bag for all the equipment.
info »
Supplied in a special synthetic case which is strong and resistant against humidity and heat. 50 mm inside diameter, 53 mm outside diameter, 51 mm long. Includes 48 plastic end covers.
info »
One piece head and rod, approximately 600 mm long with bayonet connection for use with 510-109.
info »